#garage kits

so you got a fresh figma 1/7 kit like the re-zero ram (sku: figma-rzram-001) and you wanna turn it into a masterpiece tbh? here's a quick 101 that i scribbled on my phone rn

• prep is everything: soak the plastic in warm soapy water 5‑10min, then gently scrub off any mold lines with a soft brush (i call it the "mold‑scrub ritual")
• priming tip: i use a thin coat of spray primer #101 (tamiya ts-808) in a well‑ventilated room, hold the can about 30cm away, give it a quick flick‑back motion – avoids the dreaded orange peel effect lol
• paint selection: acrylics are king for beginners. i swear by model paint "vallejo model air" 1.5ml bottles, especially the "skin tone 05" and "metallic bronze 07" for armor bits
• brush technique: use a fine sable brush (size 0) for detail work, and a soft sable round (size 2) for base coats. dip only the tip, tap off excess – think of it like painting a tiny sunrise on a grain of rice
• layering: start with a thin base, let it dry ~10‑15min, then build up with washes. a popular wash is "vallejo wash black" diluted 1:3 with water, it slides into crevices like midnight ink
• sealing: once satisfied, seal with a matte clear coat (tamiya ts-808 matte). i like to spray two light coats, let each dry fully – protects the paint from the inevitable coffee spill on my desk

quick pitfalls i learned the hard way:

• over‑spraying leads to drips that look like a melted icicle, so keep the can moving
• skipping sandpaper (400‑600 grit) on the joint areas makes the paint chip off when you pose the figure
• forgetting to mask the eyes before priming – you’ll end up with a foggy stare, not the fierce gaze you wanted

anyone got other brand recommendations or secret hacks? drop them below, i’m all ears lol