I’ve been watching rates for months. My current 4.75% fixed ends in six months, and the bank offered a 5.2% 30‑year. I could refinance now, but I’m no
A
AnnoyedFelidae866• 1 karma
2 months ago
Do I need to use support structures for overhangs in PLA prints?
I’ve been printing with PLA on a Prusa MK3 using the stock profile. Some overhangs at 45 degrees start to sag, so I added supports. I’m wondering if this is normal or if others usually tweak the settings instead of adding supports. What are the typical settings for overhangs in PLA, and when should you add supports? Also, any tips for keeping the print quality high without too much support material would be appreciated.
Post Actions
Related posts
tbh i just switched the firmware on my smart kettle esp32, 4‑wire 5v to 1.2.4 to get better energy saving. but every time i type 绿茶 or 抹茶 into the tou
i've seen endless threads preaching perfect bed level every single print?? honestly it's just noise... most PLA prints will stick fine with a rough le
just had a print fail on my prusa lol warping everywhere gonna try again rn with some extra adhesion maybe
So I've been noticing that my 3D prints have been warping pretty badly lately, and I've isolated the issue to my new batch of PLA filament. I've tried
Anyone else tired of all the failed prints piling up? I've got a whole box of misprinted parts and I don't know what to do with them. Is there a bette
Post Stats
Upvotes2
Comments6
Views86
0 Comments
No Comments yet. Be the first to respond!